Nespresso Troubleshooting Inissia

Inissia

To turn the machine on either press the Espresso or Lungo button.
To turn the machine off before automatic Power Off mode, press both the Espresso and Lungo buttons simultaneously.
With machine being turned off, press and hold the Espresso button for 3 seconds.
The Espresso button will blink to indicate the current setting.
To change this setting press the Espresso button: One time for power off mode after 9 minutes One more time for power off mode after 30 minutes.
To exit the energy saving mode press the Lungo button for 3 seconds.

Rinse then fill the water tank with potable water.
Press the Espresso or Lungo button to activate the machine.
Blinking Lights: heating up (25 sec.). Steady Lights: ready
Lift the lever completely and insert a Nespresso capsule.
Close the lever and place a cup under the coffee outlet.
Press the Espresso (40 ml) or the Lungo(110 ml) button to start. Preparation will stop automatically. To stop the coffee flow or top up your coffee, press again.
Remove the cup. Lift and close the lever to eject the capsule into the used capsule container.

To enter the emptying mode, press both the Espresso and Lungo buttons to turn the machine off.
Remove the water tank and open the lever.
Press both the Espresso and Lungo buttons for 3 seconds.
Both LEDs blink alternatively.
Close the lever.
Machine switches off automatically.
Empty and clean the used capsule container and drip tray.

With machine being turned off, press and hold down the Lungo button for 5 seconds.
LEDS will blink fast 3 times to confirm machine has been reset to factory settings.
LEDs will then continue to blink normally, as heating up, until ready. Steady lights: machine ready
Factory settings: Espresso Cup: 40 ml, Lungo Cup: 110 ml, Power Off mode: 9 min.

Remove the capsule and close the lever.
Empty the drip tray and used capsule container.
Fill the water tank with 0.5 L of potable water and add 1 Nespresso descaling liquid sachet.
Place a container (min.volume 1 L) under the coffee outlet.
To enter the descaling mode, while the machine is turned on, press both the Espresso and Lungo buttons for 3 seconds.
Both LEDs blink.
Press the Lungo button and wait until the water tank is empty.
Refill the water tank with the used descaling solution collected in the container and repeat step 4 and 6.
Empty and rinse the water tank. Fill with potable water.
When ready, repeat step 4 and 6 to now rinse the machine. Repeat twice.
To exit the descaling mode, press both the Epresso and Lungo buttons for 3 seconds.
Blinking Lights: heating up (25 sec.). Steady Lights: ready
The machine is now ready for use.

First use: fill water tank with warm water (max. 55° C) and run through machine according to instructions on 'First Use' guide or user manual
Water tank is empty.Fill water tank.
Descale if necessary; see Descaling section.